Came FERNI kit

FERNI is a complete kit for automatic control of a double-leaf gate mounted on brick or masonry posts. The maximum length of a single leaf is 4 m, and the maximum distance between the hinge and post edge is 30 cm. The operators have articulated arms and endstops – we recommend installing a stopper at the entrance.

Advantages:
- Ferni is a universal operator with articulated arm designed for gates with a leaf length of up to 4 m, installed on very large masonry posts with a width of up to 60 cm and distance between the hinge and post edge of up to 30 cm,
- in case of power outage, the operators are equipped with key switches for a convenient and safe release mechanism,
- designed for large gates mounted on masonry fences, e.g. fences around palaces, parks or mansions.

 The FERNI kit includes the following components:
- two 230-V electromechanical operators with articulated arm,
- ZF1 control board,
- control board enclosure,
- frequency card,
- DIR10 photocells,
- available remote control types: Top (2-channel) or Space (2-channel).

Specification:
- maximum gate weight with 4-m leaf length: 400 kg,
- operators should be installed on brick and masonry posts with a size of 60x60 cm or 38x38 (min. size: 340x340 mm),
- maximum motor power: 140 W,
- 90° opening time: 34 s,
- duty cycle: 30%, residential,
- thrust: 540 Nm,
- operating temperature: -20°C to +55°C.

Standard functions:
- endstops integrated into the operators enable quick and accurate adjustment of leaf opening and closing points,
- automatic closing,
- gate stopping with the remote control,
- safety even when the gate is not moving thanks to the special electronic circuit which ignores every command if an obstacle is detected by the safety devices.

Additional functions:
- partial opening of the gate to allow pedestrian passage if the control board is replaced with the ZA3 board,
- an additional photocell kit should be installed after replacing the control board with the ZA3 board.

Instructions in the link.